Ironhead Sportster Starter Problems
Ironhead Sportster Starter Problems. If your sportster isn',t giving you any trouble codes, it is unlikely to have an ignition problem, but there could still be a loose wire somewhere or a bad. Discussion starter · #1 · jun 18, 2010.
Almost all of the issues arise from the engine’s solid mount and. The bike has an s&,s carb and is. Always go back to the basics, fuel, spark, compression and timing.
Almost All Of The Issues Arise From The Engine’s Solid Mount And.
The kick lever goes down all the way and engages the engine the engine rotates normally it just wont start. I have a 74 sportster that i am tinkering with and am having problems getting starter drive to work. Overhaul (thoroughly clean, repair or replace as necessary) the the.
He Is A Smart Guy, And Works On Printing Presses For A Living.
I ended up pulling the hole assembly off bike since is was easier. I',ve got a 77 ironhead sportster that won',t start. Discussion starter · #1 · jun 18, 2010.
A Fully Charged Battery Should Be Close To 13 Volts With The Engine Off.
It should be somewhere around 14 volts if the charging system is working. For a 200 mile trip 1 always stopped 1/2 way to tighten up loose bolts. The starter works, but once the pinion gear and shaft assembly gets a load on it, it disengages and freespins.
It Was The Shift Rod Going Through The Tranny, It Had Broken In Half.
Always go back to the basics, fuel, spark, compression and timing. Stalls out pretty easy too. That plug looks rich fouled.hesitation, misfire and hard starting are the problems that go with this condition.
Understand The Oil In Your Sportster.
I had a buddy who just bought a 1979 sportster after he checker out my 1977. The bike has an s&,s carb and is. Well i had the same issue a few years ago, with an 1980 ironhead.
Post a Comment for "Ironhead Sportster Starter Problems"